MPPT solar charge controller

MPPT portable 12/24V auto recognized, 10A rated charging current.

MPPT SOLAR CHARGE CONTROLLER

Tracer1206/1210/1215

  

Introduction:

The TRACER series controller is for off-grid solar system and control the charging and discharging of the

battery. The controller features a smart tracking algorithm inside that maximizes the energy from the solar PV module(s) and charge the battery. At the same time, the low voltage disconnect function (LVD) will prevent the battery damage from battery over discharging.

The TRACER controller charging process has been optimized for long battery life and improved system performance. The comprehensive self-diagnostics and electronic protection functions can prevent damage from installation mistakes or system faults. In addition, the TRACER controller has a RJ45 interface to allow communication with a meter for remote monitoring

Key features:

 12/24V auto recognized, 10A rated charging current.

 Advance maximum power point tracking technology to optimize using the solar system ²  Widely used,automatic recognize day/night

 Timer function with 1-15 hours option for street light

 Two load outputs. Each load can be individually controlled, and enhance the flexibility of the system. ²  Sealed, Gel, and Flooded battery option

Adopting temperature compensation and correcting the charging and discharging parameters automati-cally, improving the battery lifetime

Electronic protection: Over charging, over discharging, overload, short circuit, and reverse polarity of both solar module(s) and battery.

 RJ45 interface with remote meter MT-2, convenient to check operating parameters of controllers.

1 - Charging status LED

An LED indicator that shows charging status and also indicates when a solar input fault condition exists.

2 - Battery status and load fault LED

An LED indicator that shows battery status or load fault condition exists.

 

3 -Temperature sensor

Measures ambient temperature

 

4 -Setting & Work mode indicators

Controller setting and work mode indicators

5 -Setting switch/ON/OFF switch

Setting two loads work mode and battery type

6 - RJ45 communication port

Communicate with remote meter MT-2

7 -Terminal block

Terminals for system: Solar, Battery, Load1, Load2 connections.

 

MPPT solar charge controller